Datasheet

GREENPAR
® RF CONNECTOR
CABLE ASSEMBLY
INSTRUCTION SHEET
INSTRUCTION SHEET
411-3255
REVISION A
16
TH
NOVEMBER, 2001
INTRODUCTION
The detail shown within this instruction sheet gives guidance for the assembly of the chosen cable to connector.
(Refer to the table for the applicable connector part numbers covered by this document).
The assembly instructions are in sketch form, which show the sequence of how to assemble.
The sketches are relevant for both jacks and plugs .For clarity, only one type of connector is shown.
Cable preparation should be undertaken in accordance with normal safety precautions using commercially
available cable stripping tools.
PART NUMBERS, CABLE PREPARATION AND TOOLING TABLE
connector P/N Cable Strip
Dimensions
Hand Tool Part
No.
Die Set Part
No.
A B C
1-1337473-0 21.0 16.5 1.0 not required not required
1-1337636-0 9.5 6.5 3.0 not required not required
1-1337644-0 18.5 16.5 1.0 not required not required
1-1337651-0 21.0 16.5 1.0 not required not required
1-1478234-0 18.5 16.5 1.0 not required not required
1-1478420-0 8.5 7.5 1.0 not required not required
1-1478421-0 8.5 7.5 1.0 not required not required
CABLE TO CONNECTOR DIAGRAM FOLLOWS ON NEXT PAGE.
REVISION RECORDS
A
RELEASE FOR
PRODUCTION
R.GOODALL F.W-KING F.W-KING 12 NOV 2001
REVISION DESCRIPTION DRAWN BY
CHECKED
BY
APPROVED
BY
DATE
©2001 Tyco Electronics Corporation,Harrisburg,PA.All Internatioanl Rights Reserved Page 1 of 2
“GREENPAR” is a Registered Trade Mark of Tyco Electronics Corporation