Datasheet

Page 13 / 14 ECOC: EGC0 ; LOC: AI
P/N 1-1579002-2 411-18506 Rev B
5 Exchanging of blades
(A ) Release Allan screw 11.
(B) Close the tool and remove the blades 5…8 (always exchange the blades by pairs).
(C) Attach the new blades 5…8 onto the retention pins 12 of the blade locations 1…4
(polished part internally), afterwards open the tool.
(D) Tighten the Allen screw 11 to secure the blades.
6 Stripping procedure
(E) Adjust length stop 10 to the required stripping length.
(F) Insert the cable into cable guiding 9 according to wire size.
(G) Place the cable properly by using the length stop 10.
(H) Close the tool, thus the blades 5…8 approach the cable to be stripped.
The insulation will be cut and stripped off.
(I) Open the tool again and remove the cable.
11
12
12
12