Datasheet
108-40000
3.2. Material
Materials used in the construction of this product shall be as specified on the applicable product
drawing.
3.3. Ratings
! Current: 1 ampere maxim um (single circuit energized), see Para 3.5.(b)
! Operating tem perature: -65 to 105E C, unless lim ited by tem perature rating of cable used
Continuous current rating for individual contacts cannot be applied directly to the number
NOTE
of contacts as they are dependent on thermal and physical properties of the materials.
System design shall assure that continuous current rating does not create internal hot
spots that exceed temperature designated by connector specification during steady state
or transient conditions.
3.4. Perform ance and Test Description
Product is designed to m eet the electrical, m echanical and environm ental perform ance requirem ents
specified in Figure 1. Unless otherwise specified, all tests are perform ed at am bient environmental
conditions per Test Specification 109-1.
3.5. Test Requirem ents and Procedures Summ ary
Test Description Requirem ent Procedure
Exam ination of product. Meets requirem ents of product
drawing and Application
Specification 114-40005.
Visual, dim ensional and functional
per applicable quality inspection
plan.
ELECTRICAL
Term ination resistance, dry circuit. 15 milliohm s maxim um . TE Spec 109-6-1.
Subject mated contacts assem bled
in housing to 50 m illivolt open circuit
at 100 milliam peres.
See Figure 3.
Insulation resistance. 5000 megohm s m inim um initial.
1000 megohm s m inim um final after
humidity/tem perature cycling.
TE Spec 109-28-4.
Test between adjacent contacts
within a row and contacts in
adjacent row of unm ated and
unterm inated connectors.
Dielectric withstanding voltage. One minute hold with no breakdown
or flashover.
TE Spec 109-29-1.
1000 volts DC at sea level.
Test between adjacent contacts
within a row and contacts in
adjacent row of unm ated and
unterm inated connectors.
MECHANICAL
Random vibration. No discontinuity greater than 1
microsecond.
See Note (a).
TE Spec 109-21-5, Test level G.
Subject wired and mated
connectors to 23.91 Gs rm s, 20
minutes each plane.
See Figure 4.
Figure 1 (continued)
Rev D 2 of 6