Datasheet

Figure 1

Crimping Dies 169404, used in Hand Crimping Tool

169400, are designed to crimp PIDG and

PLASTI–GRIP terminals, and PIDG “window” splices.

Read this instruction sheet for specific information

concerning the dies, applicable terminals, and wire

specifications. Read the instructions packaged with

the tool (Instruction Sheet 408–6764) for information

concerning dies installation, crimp adjustments,

crimping procedures, and general information.

See Section 6, REVISION SUMMARY, for revision

information.

Each die assembly consists of a stationary die and a

moving die. Each die assembly is also divided into

PAGE 1
Instruction Sheet 408-6765 (was IS 6765) Crimping Dies 169404 08 APR 09 Rev A PROPER USE GUIDELINES Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume applications. A wide selection of powered application equipment for extended-use, production operations is available.
PAGE 2
408-6765 Crimping Dies 169404 three separate crimping closures that are color–coded to match the color–coded terminal/splice for a given wire range. Note that Figure 1 indicates the number of dots that will appear embossed on the crimped terminal or splice. Observe the dot code on the finished crimp to ensure that correct terminal/splice and die–closure combination was used.
PAGE 3
408-6765 Crimping Dies 169404 4. DAILY MAINTENANCE Remove all foreign particles with a clean, soft brush or clean, soft, lint–free cloth. If foreign matter cannot be removed easily, or it the proper replacement parts are not available, return the dies to your supervisor. Make certain the dies are protected with a thin coat of any good SAE No. 20 motor oil. DO NOT OIL EXCESSIVELY. When the dies are not in use, store them in a clean, dry area. 5. MAINTENANCE AND INSPECTION 3.
PAGE 4
08-6765 Crimping Dies 169404 23.92 [.938] 12.7 41.28 [1.625] [.50] 25.4 [1.00] 28.45 [1.