Information

Product Specification 108-5262
Rev. C6 9 of 14
Para.
Test Items Requirements Procedures
3.5.19
Resistance to
Liquid
Detergents:
Must meet the specified
requirements after testing in
the sequence specified in
Fig.9.
Immerse mated connectors into
commercially suppliable car washer
liquid detergent at 50±2℃ for 2 hours.
After the durations, rinse in tap water
for 5 minutes, and have it dried before
subsequent measurement.
3.5.20
Resistance to
Coolant
Must meet the specified
requirements after testing in
the sequence specified in
Fig.9.
Immerse mated connectors into
commercially suppliable L.L.C (long life
coolant) at 50±2℃ for 2 hours. After
the duration, lines in tap water for 5
minutes, and have it dried before
subsequent measurement.
Immerse mated connectors into oils the
following in the specified sequence:
No. Oil Names Temperature
Dura-
tion
1
Engine Oil
(SAE 10w)
50±2℃
60
min.
2
Kerosene
Linse
Room Temp.
5
min.
3
Motor
Gasoline
Room Temp.
60
min.
3.5.21
Resistance to Oil Must meet the specified
requirements after testing in
the sequence specified in
Fig.9.
4
Drying w/o
Powered
Ventilation
Room Temp.
AS
Req’d
3.5.22
Resistance to
Ozone
Must meet the specified
requirements after testing in
the sequence specified in
Fig.9.
Suspend mated connector in a closed
container, and expose in ozone
atmosphere of 50±5ppm concentration
per JIS K 6301 , Para.16, at 40±2℃
for 24 hours. After the duration,
recondition in the room temperature,
before subsequent measurement.
Record cracking condition of tested
rubber surfaces, according to JIS K
6301, Para.16.6.
3.5.23
Weather Aging: Must meet the specified
requirements after testing in
the sequence specified in
Fig.9.
Expose mated connectors under the
sunshine carbon are light beam per JIS
D 0205, Para.5.4 (WAN-1S), Aging
Tester, at 63±3℃ for 150 hours.
Record cracking condition of tested
rubber surfaces, according to JIS K
6301, Para.16.6.