Information

114-20045
Rev. F4 Page 5 of 6
LOC I
5.1 After crimping, the part of the cable insulation that is inside the seal shall be in good
condition and within the requirements shown in Fig. 5.
Check by visual inspection in the transition area (between wire and insulation barrel),
as indicated in Fig. 6.
5.2 Crimped contacts should appear as illustrated in par. 1.1 (Nomenclature).
After crimping, the rubber
seal must protrude from
the insulation crimp
without any damage
Fig. 6
After crimping no parts of
insulation or rubber in the
wire crimp is allowed
Tilt shape of
rubber wire is
not allowed
Part of rubber seal
must stick out from
transition hole