Datasheet

114- 2157
Rev G 13 of 14
6. VISUAL AID
Figure 11 shows a typical application of PIDG terminals, splices, and end caps. This illustration should be used
by production personnel to ensure a correctly applied terminal, splice, or end cap. Applications which DO NOT
appear correct should be inspected using the information in the preceding pages of this specification and in the
instructional material shipped with the product or tooling.
FIGURE 11. VISUAL AID (CONT’D)
END OF TERMINAL, SPLICE, OR
END CAP MUST NOT
BE BENT OR DEFORMED
CRIMP MUST BE EVENLY
FORMED ACROSS CENTER
OF WIRE BARREL
INSULATION OF TERMINAL, SPLICE, OR END CAP
MUST BE FORMED OVER WIRE INSULATION
WIRE M UST BE VISIBLE
AT END OF WIRE BARREL
IF APPLICABLE, DOT CODE MUST BE
WELL FORMED AND CORRESPOND
WITH WIRE SIZE MARKING ON TOOLING
TERMINAL, SPLI C E, OR END CAP
MUST BE STRAIGHT AND NOT
TWISTED ALONG AXIS
INSULATION OF TERMINAL, SPLICE, OR END CAP
MUST BE EVENLY FORMED W ITHOUT
OVERSTRESS MARKS
WIRE INSULATION MUST BE INSIDE
METAL SLEEVE OF TERMINAL,
SPLICE, OR END CAP
INSULATION OF TERMINAL, SPLIC E, OR
END CAP MUST NOT BE CUT OR TORN
FRONT BELLMOUTH
MUST BE EVIDENT
WIRE MUST BE BOTTOMED
IN END CAP
EACH WIRE MUST BE FLUSH
TO END OF WIRE BARREL
OR BOTTOMED ON STOP