Datasheet

Introduction
AMP MCP Interconnection System
AMP MCP 1.5K Contact System
Section Catalog 1307998-2.
Revised 12-2009.
Main Catalog 1654400-1
Chapter 3 – Issued 3-2010.
All specifications subject to change. Consult Tyco Electronics for latest specifications.
3-1
AMP MCP offers
High Reliability for
Long Term Use
AMP MCP Contacts
I Basic material (CuNiSi) with
high current capacity
I 3 redundant contact points
(1.5 mm type), 4 contact
points (2.8 mm/6.3 mm
type), 6 contact points
(9.5 mm type)
I Good guiding inside the
cavity
I Protected contact spring
due to the closed box
I Overstress protection of the
contact springs
I Steel box with secondary
locking possibility from four
sides
I Protected locking lance
AMP MCP Connectors
I High reliability status
supported for long term use
I High vibration level
supported
I Perfect design to avoid
quality problems, reduce
manufacturing and service
cost
I Integrated secondary
locking device delivered in
pre-locked position
I Wire-to-wire sealed and
unsealed connectors (SWS)
I Wire-to-board sealed and
unsealed connectors (SWS)
I
Polarisation, several keyings
I Locking mechanism for
smaller connectors/mating
aid for higher numbers of
ways
The AMP MCP (Multiple Con-
tact Point) Connector System
is designed for electronic
and electrical applications in
motor vehicles.
It fullfils all requirements for
a connector system for use
in automobiles and covers a
wide range of applications.