Datasheet

408- 9278
Rev B4 of 4
2. Mate the dies until it is evident that the dies
have bottomed, then HOLD in this position. Do
NOT force the dies beyond initial contact.
3. Align the GO element with the crimping
chamber. Push element straight into the crimping
chamber without using force. The GO element
must pass completely through. Refer to Figure 5.
4. Now align the NO--GO element and try to insert
it straight into the same crimping chamber . The
NO--GO element may start entry but must not pass
completely through as shown in Figure 5.
If the crimping chambers conform to the gage
inspection, the die assembly is considered
dimensionally correct and should be lubricated with a
THIN coat of any good SAE 20 motor oil. If not, the
die assembly must be repaired before returning it to
service. See Section 6, REPLACEMENT AND
REPAIR.
For additional information concerning the use of the
plug gage, refer to Instruction Sheet 408--7424.
6. REPLACEMENT AND REPAIR
Replacement parts or recommended spares are listed
in Figure 6. The recommended spares should be
stocked for immediate replacement. Order
replacement parts through your TE Representative or
call 1--800--526--5142, or send a facsimile of your
purchase order to 1--717--986--7605, or write to:
CUSTOMER SERVICE (38--35)
TYCO ELECTRONICS CORPORATION
P.O. BOX 3608
HARRISBURG, PA 17105--3608
When repair is necessary, please contact a TE
Representative at 1--800--526--5136.
7. REVISION SUMMARY
S Updated document to corporate requirements
S New logo
57.86
[2.278]
(Mated)
15.82
[.623]
27.05
[1.065]
1
2
Color Dot Code:
Die Assembly 58079--3 (Red)
Die Assembly 58080--3 (Blue)
WEIGHT: 595g[1.5oz]
REPLACEMENT PARTS
ITEM PART NUMBER DESCRIPTION QTY PER ASSEMBLY
1 3--21000--4 SCREW, Die Retention 1
2 21027--3 WRENCH, Hex 1
Figure 6