Datasheet

Instruction Sheet
PRO- CRIMPER* III Hand Crimping
Tool Assembly 58495- 1
408--9819
LOC B
1 of 6
E2009 Tyco Electronics Corporation, Harrisburg, PA
All International Rights Reserved
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
TOOLING ASSISTANCE CENTER 1--800--722--1111
PRODUCT INFORMATION 1--800--522--6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
22 JUL 09 Rev CWith Die Assembly 58495- 2
PROPER USE G UIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended--use, production operations is available.
Stationary Jaw
Back of Tool
(Wire Side)
Pivot Pin
PRO--CRIMPER III Hand
Crimping Tool Frame
354940--1 (408--9930)
Stationary
Handle
Moving Handle
The PRO--CRIMPER III Hand Crimping Tool is a “Commercial” grade tool
and is designed primarily for field installation, repair, maintenance work, or
prototyping in industrial, commercial, or institutional applications. Product
crimped with this tool will meet the crimp height requirement for hand tools in
the appropriate 114 series specification, but may not comply with other feature
parameters of the specification. Tyco Electronics offers a variety of tools to
satisfy your performance requirements. For additional information, contact
the Technical Assistance Center at 1-- 800 --722--1111.
Ratchet
Adjustment
Wheel
Locator
Assembly
(Supplied with
Die Assembly)
Front of Tool
(Locator Side)
Die Assembly
Moving Jaw
T
E
D
i
e
L
o
c
a
t
o
r
C
o
n
t
a
c
t
Wire
T
E
D
i
e
Assembly
L
oca
t
or
Assembly
{
C
on
t
ac
t
Family
}
Size
(AWG)
Insul
Dia
Strip Length
(mm [In.])
M
u
l
t
i
m
a
t
e
28--24
.89to1.40
[.035 to .055]
58495--2 58515--1
M
u
l
t
i
m
a
t
e
Type III(+) and
Type VI
C
t
t
24--20
1.02 to 2.03
[.040 to .080]
3.17
[.125]
Contacts
18--16
2.03 to 2.54
[.080 to .100]
{
Supplied with die assembly. Also available separately.
}
Contact the Technical Assistance Center or Product Information (below) for
specific product information.
Figure 1
1. INTRODUCTION
PRO--CRIMPER III Hand Crimping Tool Assembly
58495--1 consists of Die Assembly 58495--2 and
PRO--CRIMPER III Hand Crimping Tool Frame
354940--1. The die assembly consists of crimping
dies and a locator assembly.
Read these instructions thoroughly before crimping
any contacts.
Dimensions on this sheet are in millimeters [with
inch equivalents provided in brackets]. Figures
and illustrations are for identification only and are
not drawn to scale.
Reasons for reissue are provided in Section 11,
REVISION SUMMARY.
NOTE
i