Datasheet

Instruction Sheet
PRO- CRIMPER* III Hand Crimping
Tool Assembly 58535- 1 with
408--4021
LOC B
1 of 6
E2009 Tyco Electronics Corporation, Harrisburg, PA
All International Rights Reserved
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
TOOLING ASSISTANCE CENTER 1--800--722--1111
PRODUCT INFORMATION 1--800--522--6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
29 JUL 09 Rev CDie Assembly 58535- 2
PROPER USE G UIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended--use, production operations is available.
Moving Jaw
Stationary Jaw
PRO--CRIMPER III
Hand Crimping Tool
Frame 345940--1
(408--9930)
Pivot Pin
Stationary
Handle
Moving Handle
Ratchet
Adjustment
Wheel
Front of Tool
(Lower Side)
Die
Assembly
Locator
Assembly
(Supplied with
Die Assembly)
The PRO--CRIMPER III Hand Crimping Tool Assembly is a “Commercial”
grade tool and is designed primarily for field installation, repair, maintenance
work, or prototyping in industrial, commercial, or institutional applications.
Product crimped with this tool will meet the crimp height requirement for hand
tools in the appropriate 114 series specification, but may not comply with other
feature parameters of the specification. Tyco Electronics offers a variety of
tools to satisfy your performance requirements. For additional information,
contact the Technical Assistance Center at 1 --800 --722 -- 1111.
Back of Tool
(Wire Side)
{
C
o
n
t
a
c
t
Wire
TE Die Assembly
Locator Assembly
{
C
on
t
ac
t
Family
}
Size
(AWG)
Ins. Dia.
(mm [In.])
Strip Length
(mm [In.])
58535--2 58516--1
FFC Round Wire
Pin and Receptacle
Contacts
26--22
1.0to1.4
[.040 to .056]
2.8to3.6
.110 to .140
}
Supplied with Die Assembly.. Also Available separately.
}
Contact the Technical Assistance Center or Product Information (see below) for specific contact part numbers.
Figure 1
1. INTRODUCTION
PRO--CRIMPER III Hand Crimping Tool
Assembly 58535--1 consists of Die Assembly
58535--2 and PRO--CRIMPER III Hand Crimping Tool
Frame 354940--1. The die assembly consists of
crimping dies and a locator assembly.
Read these instructions thoroughly before crimping
any contacts.
Dimensions on this sheet are in millimeters [with
inch equivalents provided in brackets]. Figures
and illustrations are for identification only and are
not drawn to scale.
Reasons for reissue are provided in Section 11,
REVISION SUMMARY.
2. DESCRIPTION (Figures 1 and 2)
The tool features a tool frame with a stationary jaw
and handle, a moving jaw, a moving handle, and an
NOTE
i