Datasheet

Pistol Grip Hand Tool System
for Insulation Displacement Connectors (IDCs)
Pistol Grip Manual
Handle Assembly
Part Number 58074-1
A basic hand tool requires a
h
andle assembly and a termi-
n
ating head, ordered sepa-
rately, shown on page 4.
● Lightweight, easy to use
● Ratchet control will not
r
elease cam trigger until it
i
s fully bottomed
● R
atchet release
● “
U”-shaped key slides into
h
andle to hold interchange-
a
ble heads securely
● M
aterial (handle) — Molded
nylon
Specifications
Length — 3.75 [95.2]
Width — 1.12 [28.6]
Height — 4.00 [101.6]
Grip Span — 2.50 [63.5] over
trigger/handle
Weight — 3.5 oz [99 g]
Cycle Time — 0.7 - 0.8 s
Pistol Grip Pneumatic
Handle Assembly
Part Number 58075-1
● Lightweight
● Power assist for less
operator effort
● Push-button trigger
actuated
● Quiet — 78 dB max.
● “U”-shaped key slides into
handle to secure inter-
changeable heads
● Material (handle) — Molded
nylon
Specifications
Length — 4.88 [124]
Width — 1.13 [28.7]
Height — 6.00 [152]
Grip Span — 2.50 [63.5] over push-
button trigger/handle
Weight — 18 oz [510 g]
Air Pressure — 40 - 70 psi
[2.76 - 4.83 bar]
Air Supply Line (1) — 7 ft [2.13 m]
long, 3/16 [4.76] I.D. with 1/8 [3.18]
NPT fitting
Cycle Time — 0.7 - 0.8 s
Bench Mount
Pneumatic Power Unit
Part Number 58338-1
Assembly consists of a bench
mount with attached pneu-
matic power unit, a foot
switch, and two air lines
which connect the switch to
the power unit and the air
source to the switch.
Mounting hardware is not
included.
● Mounting bracket allows
interchangeable heads to
be pointed up or down to
suit operator
● Power assist for greater
productivity
● Actuated by foot switch
● Key retains heads, or heads
and feed tracks
Specifications
Outside Diameter — 1.62 [41.2]
Length — 5.00 [127]
Height — 7.00 [178]
Weight — 2 lb [0.91 kg]
Air Pressure — 40 - 70 psi
[2.76 - 4.83 bar]
Air Lines (2) — 7 ft [2.13 m] long,
3/16 [4.76] I.D. with 1/8 [3.18]
NPT fitting
Cycle Time — 0.7 - 0.8 s
Application Rates (Typ.) —
600 terminations per hr;
1 100 terminations per hr with optional
Loose-Piece Feed Track; and
1 250 terminations per hr with optional
Tape (Reel) Feed Track (when produc-
ing 6 in [15 cm] jumpers, one
4-pos. MTA-100 connector each end,
discrete wire)
Bench Mount Power Units
Notes: 1. Interchangeable terminating heads must be ordered separately, see page 4.
2. Loose-piece or tape (reel) feed track accessories are available, see page 3.
Pistol Grip Power Units