Datasheet

ManualsBrandsTE Connectivity ManualsConnector ToolsCrimping Tool

Figure 1

PRO–CRIMPER III Hand Crimping Tool Assembly

58583–1 consists of Die Assembly 58583–2 and

PRO–CRIMPER III Hand Crimping Tool Frame

354940–1.

The die assembly consists of crimping dies and a

locator assembly.

Read these instructions thoroughly before crimping

any contacts.

Summary of content (5 pages)

PAGE 1
Instruction Sheet PRO-CRIMPER* III Hand Crimping 408-4165 Tool Assembly 58583-1 with Die Assembly 58583-2 12 MAY 09 Rev A PROPER USE GUIDELINES Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume applications. A wide selection of powered application equipment for extended-use, production operations is available.
PAGE 2
408-4165 PRO-CRIMPER III Hand Crimping Tool Assembly 58583-1 Locator Nut Assembly Tool Frame Locator Die Retaining Pins Insulation Crimper Chamfer Wire Crimper Offset Wire Anvil Insulation Anvil Chamfer Die Retaining Screws Figure 2 2. DESCRIPTION (Figures 1 and 2) The tool features a tool frame with a stationary jaw and handle, a moving jaw, a moving handle, and an adjustable ratchet that ensures full contact crimping. The tool frame holds a die assembly with three crimping chambers.
PAGE 3
408-4165 PRO-CRIMPER III Hand Crimping Tool Assembly 58583-1 assembly, the two die retaining screws, and the four die retaining pins, and slide the anvils and crimpers out of the tool jaws. 8. Make another sample crimp. If the contact is straight, tighten the contact support screw. If the contact is still being bent during crimping, repeat the adjustment procedure. 4. CONTACT SUPPORT ADJUSTMENT (Figure 3) NOTE 5.
PAGE 4
08-4165 PRO-CRIMPER III Hand Crimping Tool Assembly 58583-1 CAUTION ! Make sure that both sides of the insulation barrel Position Point are started evenly into the crimping chamber. on Center of Do NOT attempt to crimp an improperly Wire Barrel positioned contact. Opposite Seam 4. Hold the contact in position and squeeze the tool handles together until ratchet engages sufficiently to hold the contact in position. Do NOT deform insulation barrel or wire barrel. 5.
PAGE 5
408-4165 PRO-CRIMPER III Hand Crimping Tool Assembly 58583-1 8. MAINTENANCE Ensure that the tool and dies are clean by wiping them with a clean, soft cloth. Remove any debris with a clean, soft brush. Do not use objects that could damage the tool. When not in use, keep handles closed to prevent objects from becoming lodged in the crimping dies, and store in a clean, dry area.