Datasheet

Instruction Sheet
PRO- CRIMPER* III Hand
Crimping Tool Assembly 58654- 1
408--4458
LOC B
1 of 6
E2009 Tyco Electronics Corporation, Harrisburg, PA
All International Rights Reserved
TE logo and T yco Electronics are trademar ks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
TOOLING ASSISTANCE CENTER 1--800--722--1111
PRODUCT INFORMATION 1--800--522--6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
29 JUL 09 Rev Bwith Die A ssembly 58654- 2
PROPER USE GUIDELINES
Cumulative Trauma Disorders can resultfrom the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended--use, production operations is available.
The PRO--CRIMPER III Hand Crimping Tool Assembly is a “Commercial”
grade tool and is designed primarily for field installation, repair, maintenance
work, or prototyping in industrial, commercial, or institutional applications.
Product crimped with this tool will meet the crimp height requirement for hand
tools in the appropriate 114 series specification, but may not comply with other
feature parameters of the specification. Tyco Electronics offers a variety of
tools to satisfy your performance requirements. For additional information,
contact the Tooling Assistance Center at 1--800--722--1111.
L
ocator
A
ssembly
(Supplied with
Die Assembly)
Front of Tool
(Locator Side)
Die Assembly
Moving Jaw
Ratchet Adjustment
Wheel
Moving Handle
Stationary Handle
Pivot Pin
Back of Tool
(Wire Side)
Stationary Jaw
PRO--CRIMPER III Hand
Crimping Tool Frame
354940--1 (408--9930)
T
E
D
i
e
L
o
c
a
t
o
r
C
o
n
t
a
c
t
Wire
TE Die
Assembly
Locator
Assembly{
Contact
Family}
Size
(AWG)
Insul Dia
(mm [In.])
Strip Length
(mm [In.])
58654--2 58516--1
AMPMODU* II
Contacts
181270--1
30--22
1.42
[.056]
Max.
2.54
[.100]
{ Supplied with die assembly. Also available separately.
} Contact the Tooling Assistance Center or Product Information (see below) for specific contact part numbers.
Figure 1
1. I NTRODUCTION
PRO--CRIMPER III Hand Crimping Tool
Assembly 58654--1 consists of Die Assembly
58654--2 and PRO--CRIMPER III Hand Crimping Tool
Frame 354940--1. The die assembly consists of
crimping dies and a locator assembly.
Read these instructions thoroughly before crimping
any contacts.
Reasons for revision can be found in Section 11,
REVISION SUMMARY.
Dimensions on this sheet are in millimeters [with
inch equivalents provided in brackets]. Figures
and illustrations are for identification only and are
not drawn to scale.
2. DESCRI PTION (Figures 1 and Figure 2)
The tool features a tool frame with a stationary jaw
and handle, a moving jaw, a moving handle, and an
adjustable ratchet that ensures full contact crimping.
The tool frame holds a die assembly with three
crimping sections.
NOTE
i