Information

114-13065
6 of 10
Rev C
Figure 6
7. By pushing the CPA toward the plug housing, it can be slid into the locked position in which it slides
under the connector latch pad. See Figure 7.
Figure 7
B. Disassembly
Damaged or misplaced contacts can be replaced on an individual basis. Refer to Figure 8 and separate the
connector and remove the contact by the following procedures:
1. Slide the CPA toward the rear (wire end) of the cap housing assembly to reveal the connector latch tip.
See Figure 8.
Loaded Contacts
NOTE: Make sure that the
plug connector latch tip is in a
fully horizontal position to be
completely latched and
locked with the cap
assembly.
Cap Assembly
Assemblies
Fully Mated
Connector Latch Pad
(Fully Locked)
CPA in
Unlocked
Position
Loaded Contacts
Plug Assembly
Cap Assembly
Plug Connector
Latch Tip
Plug and Cap
Latch Engaged
Connector Latches and
Assemblies (Fully Mated
and Locked)
Plug Assembly
Connector
Latch Pad
CPA (Locked Position)
Cap Assembly