Information

108-2184
Test Description Requirem ent Procedure
ELECTRICAL
Low signal term ination resistance. 6 m illiohm s maxim um for 14 and 16
AW G wire.
9 m illiohm s maxim um for 18 AW G
wire.
SAE J2030 6.2.
Measure connection resistance
across m ated term inals and
subtract bulk resistance of Equal
W ire Lengths (EW L).
Voltage drop. W ire Test Voltage Drop
Size Current (m illivolts
(AW G) (am peres) m axim um )
14 13 100
16 10 100
18 8 100
SAE J2030 6.4.
Averaged m easurem ents after 30
seconds, 15 m inutes and 30
minutes of current being applied.
EW L subtracted.
Insulation resistance. 20 m egohms minimum . SAE J2030 6.3.
Insulation resistance at 1000 volts
DC adjacent term inals m easured
after 60 seconds or until
stabilization occurs.
MECHANICAL
Random vibration. No discontinuities.
See Note.
EIA-364-28.
Subject m ated specim ens to 21 G's
rm s between 25 to 2000 Hz.
Twenty hours in each of 3 m utually
perpendicular planes.
Durability. See Note. SAE J2030 6.11.
50 cycles.
Terminal retention, axial. Contacts shall not dislodge m ore
than 0.8 m m.
IEC 512-8, Test 51a.
Apply axial load of 111 N to
contacts at a m axim um rate of 10 N
per second (or 50 m m per m inute)
and hold for 10 seconds.
Mating/unm ating force. 135 N m axim um . SAE J2030 6.9. and 6.10.
Measure force necessary to m ate
and unmate specim ens at a
maxim um rate of 50 m m per
minute.
Polarizing m ism ating force. 220 N m inim um . SAE J2030 6.21.
Attempt to m ate specim en against
polarizing or keying feature.
Maintenance aging. See Note. SAE J2030 6.6.
Insert and rem ove term inal for 8
cycles on 20% of the term inals.
ENVIRONMENTAL
Tem perature life. See Note. EIA-364-17.
Subject specimens to 120 ± 3° C
for 500 hours.
Figure 2 (continued)
Rev B 3 of 6