Information

Insertion Machines for Single Contacts
Timer Interconnection System
Application Tooling and Equipment
Catalog 889759-3
Revised 7-2011
All specifications subject to change. Consult TE Connectivity for latest specifications.
2-182
For more detailed information please visit our websites:
www.tooling.te.com • www.tooling.te.com/europe • www.tooling.te.com/china
The P 350 is a fully-automatic
insertion machine with the
ability to handle a large variety
of TE Connectivity terminals
as well as customer specific
terminals. A standard P 350
machine comes with 3 base
insertion tools mounted onto
an automatic tool changer.
The tool changer can take up
to 4 insertion tools/support
tools. These base tools can
easily be equipped with
existing or customer specific
conversion kits for a large
range of terminals.
All heads are equipped with
rotary insertion fingers to allow
the insertion of terminals at
different angles without the
need to rotate the board.
The PCB transfer belts enable
the machine to be incorpo-
rated into an automatic
production line.
A standard Insertion Force
Monitoring system allows for
real-time force monitoring for
100% quality assurance for
each press-fit terminal. Its
operator interface has been
P 350 Fully-Automatic
Insertion Machine
for High Volumes
Single Pin
Repair Station
designed for easy use and
provides the insertion force
and a variety of production
data to be collected at an open
interface. With a maximum
insertion rate of 4.5 cycles per
second we provide a produc-
tion capacity which is difficult
to match in the market place.
The programmable insertion
of two 0.63 mm pins per cycle
doubles the output.
A loose-piece pin or tab is
placed in the product specific
insertion finger of the arbor
press, the PCB is placed on
the support anvil and the pin
or tab is manually pressed
into the board.
P 50 Manual Bench
Insertion Machine
The P 50 Insertion machine
is a manual operated bench
machine for low volume
production, repair work and
sample production.
It uses a trader slide to
position the PCB under the
pneumatic insertion head.
A regular PCB is used as
master to position the indexing
pin above the insertion hole.
When activating the two
hand start, the indexing pin
extracts. If a hole is detected,
the terminal is inserted into
the board in production.