Datasheet

Mini- Universal MATE- N- LOK Splash- Proof Sealed Connectors
114- 13089
Rev B 15 of 20Tyco Electronics Corporation
Figure 16
Right--Angle Pin Header Vertical Pin Header
Solder Fillet Evenly Formed Around Each Contact with No Skips or Voids
(No Solder on Boardlocks)
3.15. Panel Cutout
The cap housings are designed to be panel mounted. The panel thickness range must be 0.8 through 2.0 mm
[.031 through .079 in.]. The panel cutout must conform to the dimensions provided in Figure 17.
Panel Cutout
3.35 [.132]
1.60 [.063]
5.36 [.211]
2.49 [.098]
10.34 [.407]
B (See Table)
A (See Table)
B (See Table)
CAP HOUSING
PA N EL DIMENSION
C
A
P
H
O
U
S
I
N
G
No. of Positions
A
B
2 10.69 [.421] 6.15 [.242]
4 14.91 [.587] 10.34 [.407]
6 19.10 [.752] 14.55 [.573]
8 23.29 [.917] 18.72 [.737]
10 27.50 [1.083] 22.96 [.904]
Figure 17
3.16. Mounting Cap Housing in Panel
The cap housing must be inserted (mating face first) through the panel cutout in the same direction as the
punch. The panel stops must be flush with the panel, and the mounting ears must be against the panel. The
serrations on the mounting ears are designed to ensure a tight fit between the connector and panel by
accommodating any of the panel thicknesses within range. See Figure 18.
Before removing the cap housing from the panel, the mounting ears must be deflected until clear of the panel.
The cap housing can be removed from either the front or back of the panel.