Datasheet

Mini- Universal MATE- N- LOK Splash- Proof Sealed Connect ors 114- 13089
Rev B16 of 20 Tyco Electronics Corporation
Figure 18
Panel Stop (4 Places)
Flush with Panel
Mating Face of
Cap Housing
Wires
Side View
Top View
Wires
Install
Mounting Ear Against Panel Cutout
Punch Side of Panel (Ref)
Mounting Ear Against Panel Cutout
Mounting Ear (See Also Top View)
Deflect to Remove
Deflect to Remove
3.17. Mating and Unmating
Mating connectors must have identical number of positions. When mating, the housing must be pushed
straight into the housing or header. The locking latch of the plug housing must engage and be fully seated on
the locking tab of the cap housing or pin header after mating. The interface seal must be flat and compressed
against the back of the channel at the base of the silos of the plug housing. Refer to Figure 19.
The locking latch of the plug housing must be depressed to release the locking tab of the cap housing or pin
header. The plug housing must be pulled straight out of the mating connector. After unmating the connectors,
the interface seal must be inspected for damage or twisting. If damaged or twisted, the interface seal must be
replaced before re--mating the connectors.
Figure 19
Note: Cap Housing Shown, Requirements Equally Apply to Pin Header
Locking Tab
Locking Latch
Plug Housing
Cap Housing