Datasheet

AMP Micro-MaTch
Miniature Connector System
General Information
Product Facts
One of the smallest systems available at 1.27 mm
UL-recognized: File No. E28476, Vol. 23, Section 4
High performance/cost ratio
Wire connectors supplied on-tape and suitable for mass termination of 28 AWG [0.08
mm
2
to 0.09 mm
2
] ribbon cable
Tin plated contact design
Guaranteed minimum contact force of 2.0 N
Fretting corrosion proof thanks to additional positioning spring member
Fully plated contacts: no bare edges and no migration of corrosion products
Contacts fully protected by polyester housings, except for side-entry female board
connector
Full range of application tooling from hand tool to fully automated equipment
Board connectors supplied on-tape.
Description
The AMP Micro-MaTch connector family, with its contact spacing of 1.27mm, fully
complies with the electronic packaging requirements of today and the future.
Miniaturization and the trend toward higher density of electronic functions on a substrate led
to the introduction of smaller interconnection systems.
The system offers a range of board and wire connectors, enabling a variety of wire-to-board
and board-to-board interconnections.
The AMP Micro-MaTch contact concept is essentially different from other systems available.
The contact spring is located in the board connector and not in the cable connector, which is
usually the case.
The counter part, incorporated in the cable connector, is a simple pin, either with an
insulation displacement section, suitable for the mass termination of cable or with a kinked
1 av 3
solder leg to be soldered onto a pc board.