Datasheet
Siemens Aktiengesellschaft 35
Steckverbinder PC 612
Connectors PC 612
Sonderbauformen Special types
Sonderbauformen
●
Messerleisten mit „voreilenden“ Kontaktmessern.
●
Teilbestückung von Messer- und Federleisten.
●
Kombinationen aus beiden genannten Sonderbauformen
●
Steckverbinder in flußmitteldichter Ausführung.
●
Steckverbinder mit hochtemperaturbeständigem Isolier-
körper.
●
Federleiste mit Lötstiften für LP-Loch Ø 0,8
Ausführungen, Einbaubedingungen und Bestellangaben
können mit dem ausgefüllten Formular (siehe Seite 36) bei
der zuständigen Siemens-Geschäftsstelle angefragt werden.
Special types
●
Male connectors with „pre-mating“ contact blades.
●
Partial complement of male and female connectors.
●
A combination of both the above types.
●
Connectors, flux-tight version.
●
Connector with high temperature-resistant dielectric.
●
Female connector with solder pins for PC board hole Ø
0.8
Details of versions, installation conditions and ordering infor-
mation can be obtained from the responsible Siemens office
by completing the form (see page 37).
Bei der Anschlußbelegung sind die gewünschten Kontakte
einzuzeichnen:
+ Kontakt
v voreilender Kontakt
o ohne Kontakt
❍
unbestückte Aufnahmelöcher (bei den
Bauformen M, M/2 und M/3)
The required contacts must be drawn in on the pin assign-
ment diagram:
+ Contact
v Pre-mating contact
o No contact
❍
Unequipped locating holes (on Types M, M/2
and M/3)
Beispiel:
Kurzbauform M/2, Bestückung:
2 unbestückte Aufnahmelöcher
4 voreilende NF-Kontakte auf b13, a13, b12 und a12
Rest NF-Kontakte
Example:
Short-length Type M/2, complement:
2 unequipped locating holes
4 pre-mating contacts at b13, a13, b12 and a12
Remainder contacts
(Ausschnitt aus dem Formular Seite 36) (Taken from the form on page 37)
+ 0,1
− 0,05
+ 0.1
− 0.05
++++++++VV
++++++++++
a
b
c
a
b
c
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
M
M/2
M/3
++++++++VV
a
b
c