User manual

These tools use the interchangeable mandrels listed in Figure 3. For product–to–tooling cross–reference, refer
to Figure 3.
Figure 3
Prior to operation be sure to check the following items and make any necessary adjustments to the tool.
1. Be sure that the mandrel is properly installed as described in Paragraph 3.2.
2. Be sure that the tool is properly loaded with product as described in Paragraph 3.3.
3. Be sure that the clip positioning adjustment is set as described in Paragraph 4.1, and that the clip
positioning assembly adjustment is correct (refer to Paragraph 4.2).
4. Be sure that the insulation stripping adjustment is correct as described in Paragraph 4.3.
5. Be sure that the push rod adjustment is correct (refer to Paragraph 4.4) and the distance between the
clip and the mandrel is as specified in Figure 12.