Datasheet

Instruction Sheet
PRO- CRIMPER* III Hand
Crimping Tool Assembly 91337- 1
408--8378
LOC B
1 of 5
E2009 Tyco Electronics Corporation, Harrisburg, PA
All International Rights Reserved
TE logo and T yco Electronics are trademar ks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
TOOLING ASSISTANCE CENTER 1--800--722--1111
PRODUCT INFORMATION 1--800--522--6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
23 JUL 09 Rev Awith Die A ssembly 91337- 2
PROPER USE GUIDELINES
Cumulative Trauma Disorders can resultfrom the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended--use, production operations is available.
The PRO--CRIMPER III Hand Crimping Tool is a “Commercial” grade tool
and is designed primarily for field installation, repair, maintenance work, or
prototyping in industrial, commercial, or institutional applications. Product
crimped with this tool will meet the crimp height requirement for hand tools in
the appropriate 114 series specification, but may not comply with other feature
parameters of the specification. Tyco Electronics offers a variety of tools to
satisfy your performance requirements. For additional information, contact the
Tooling Assistance Center at 1--800--722--1111.
Locator Assembly
(Supplied with
Die Assembly)
Front of Tool
(Locator Side)
Die Assembly
Moving Jaw
Ratchet Adjustment Wheel
Moving Handle
Stationary Handle
Pivot Pin
Back of Tool
(Wire Side)
Stationary Jaw
PRO--CRIMPER III Hand
Crimping Tool Frame
354940--1 (408--9930)
T
E
D
i
e
L
o
c
a
t
o
r
P
r
o
d
u
c
t
Wire
TE Die
Assembly
Locator
Assembly{
Product
Family}
Size
(AWG)
Insulation
Diameter (Max.)
Strip Length
9
1
3
3
7
2
5
8
5
1
5
1
S
i
z
e
1
6
C
o
n
t
a
c
t
s
18 2.54 [.100]
3
8
1
[
1
5
0
]
91337--2 58515--1 Size 16 Contacts
16--14 3.18 [.125]
3.81 [.150
]
{ Supplied with die assembly. Also available separately.
} Contact the Tooling Assistance Center or Product Information (at the numbers listed below) for specific contact part numbers.
Figure 1
1. INTRODUCTION
PRO--CRIMPER III Hand Crimping Tool Assembly
91337--1 consists of Die Assembly 91337--2 and
PRO--CRIMPER III Hand Tool Frame 354940--1. The
die assembly consists of crimping dies and a locator
assembly.
Read these instructions thoroughly before crimping
any contacts.
All dimensions on this document are in
millimeters [with inches in brackets]. Figures are
not drawn to scale.
Reasons for revision are listed in Section 10,
REVISION SUMMARY.
2. DESCRIPTION
The tool features a tool frame with a stationary jaw
and handle, moving jaw, moving handle, and
adjustable ratchet that ensures full contact crimping.
The tool frame holds a die assembly with two
crimping chambers. See Figure 1.
The die assembly features a wire anvil, insulation
anvil, wire crimper, and insulation crimper.
NOTE
i