Datasheet

114-18025
Rev T 4 of 21
1. SCOPE
This specification contains the guidelines for the application of pin and socket contacts of the MQS contact
system with single-wire seals. It applies primarily to the fully or semi-automatic application of the contacts; if
agreed, it can also be applied to manual crimp tools.
The contacts are listed by their use, the wire size ranges and crimping data in section 6.
Note:
Only the TE crimp tools specified in section 6 may be used for application of the contacts. Any exceptions to this
rule are defined by customer-specific documents.
2. REFERENCED DOCUMENTS
2.1 Customer Drawings
The dimensions and materials of the contacts are shown in the TE customer drawings.
Product group drawing for MQS contact ................ 929454
Product group drawing for MQS pin contact .......... 929453
2.2 Product Specification
The product specification 108-18030 describes the characteristics of the MQS contact system.
The product specification 108-18403 describes the characteristics of the single-wire seals.
2.3 Application Specifications
The crimp quality must also comply with the general guidelines laid down in the application specification
114-18022. If this is not available, it must be ordered separately.
Application specification 114-18021 applies to the application of standard MQS contacts.
Crimper and anvil dimensions: see specification 114-18025-10 (restricted).
2.4 Informational Material
CM 5128 contains information about crimping machines for MQC crimp tools.
AI 8025 describes the MQC crimp tool.
The operating instructions 412-18030 describe the handling of the MQS Scat module.
2.5 Inspection Instructions
The inspection instructions 109-18004 contain the electrical and mechanical inspections.
2.6 Information Sheets
IS 7424 explains how to measure the crimp height.