x10 DVD Duplicator User’s Manual Model DVW-D110H
Safety Precautions TEAC DVD Duplicator systems are high-precision electronic devices. Do not use them in any manner other than as specified in this manual. Please read this manual in its entirety before you begin the installation procedure. Use of controls, adjustments, or performance of procedures other than those specified herein may result in hazardous radiation exposure. To prevent fire or shock, do not expose the unit to moisture or rain.
About This Manual This TEAC 1x10 DVD Duplicator User’s Manual explains how to operate the TEAC DVD Duplicator. It is divided into the following chapters: Chapter 1: Introduction This chapter describes the shipping package contents and introduces the TEAC DVD Duplicator. Chapter 2: Using the DVD Duplicator This chapter explains how to set up the DVD Duplicator. It also details its basic copy operation. Chapter 3: DVD Duplicator Functions This chapter explains all available functions of the DVD Duplicator.
Table of Contents Table of Contents Safety Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . i Copyright and Trademark Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . i Piracy Statement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . i About This Manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table of Contents Enable Send OPC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 Support UPC/ISRC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 Region Free Set . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 Partition Size . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
List of Figures Figure 1. DVD Duplicator Unit Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Figure 2. Front Panel of the DVD Duplicator Unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Figure 3. LCD Control Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Figure 4. Rear Panel of the DVD Duplicator Unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Figure 5. Test Function on LCD Panel . .
vi TEAC 1x10 DVD Duplicator User’s Manual
Chapter 1. Introduction Thank you for purchasing a TEAC 1x10 DVD Duplicator. The TEAC 1x10 DVD Duplicator is a stand-alone disc-to-disc DVD Duplicator system that does not require connection to a computer. It can duplicate a single master DVD to DVD media at up to 16X speeds, resulting in an exact replica of a 4.7GB disc. It can also duplicate discs to CD-R media. The TEAC DVD Duplicator is designed to perform DVD copying quickly and accurately.
DVD Duplicator Package Contents DVD Duplicator Package Contents Your TEAC DVD Duplicator package includes the following items (see Figure 1). ❑ TEAC 1x10 DVD Duplicator unit ❑ ❑ AC power cable TEAC 1x10 DVD Duplicator User’s Manual (this manual on CD-ROM) 1x10 DVD Duplicator User’s Manual (in PDF format on CD-ROM) AC power cable Figure 1. DVD Duplicator Unit Package Contents Note: If any of the items above is missing from your package upon purchase, please contact your vendor immediately.
Front Panel Front Panel Figure 2 illustrates the front panel of the DVD Duplicator unit. source drive target drives LCD control panel target drives LED status indicator power switch stabilizing feet Figure 2. Front Panel of the DVD Duplicator Unit source drive: Insert the disc to be copied into the source drive. Use the disc tray to load a DVD into the drive. You can open the tray by pressing the eject button (if the tray fails to open, you can use the emergency eject mechanism).
Front Panel LCD control panel: Use the control panel buttons to navigate through the various functions viewed on the LCD display. Figure 3. LCD Control Panel The DVD Duplicator control panel features an LCD display and two buttons. These buttons are described in the following table: In Operation mode, press the SET button to scroll up through the functions or menus. In Operation mode, press the RUN button to execute the selected function.
Rear Panel Rear Panel Figure 4 illustrates the rear panel of the DVD Duplicator unit. cooling fans AC voltage selector AC IN power connector cooling fans Figure 4. Rear Panel of the DVD Duplicator Unit cooling fans: Ball-bearing fans cool the DVD Duplicator. AC voltage selector: Use this switch to select either 115VAC or 220VAC. Caution: Before you turn on the power to the DVD Duplicator, make sure the correct voltage is selected. Otherwise, you risk damage to the unit. The default setting is 115VAC.
Rear Panel 6 TEAC 1x10 DVD Duplicator User’s Manual
Setup Chapter 2. Using the DVD Duplicator This chapter explains how to set up the DVD Duplicator, as well as basic operation and menu functions. Setup 1. Select a well-ventilated area for the DVD Duplicator. Carefully remove the DVD Duplicator unit, AC power cord and user’s manual CD-ROM from the shipping box. Note: Please keep the original box and packaging materials for use in the event of future storage or transportation of the unit. 2.
Basic Operation Basic Operation This section explains the basic operation of the DVD Duplicator. Copying from the Optical (DVD) Source Drive 1. Place a source disc in the disc tray of the source drive. 2. Switch to the Copy function by pressing the SET button. 3. Place a blank DVD±R disc into as many of the target drives as you desire, then press the RUN button to start copying. You do not need to insert a DVD disc into every available target drive. You can make fewer copies if you prefer.
Loading Data to and Copying from the Hard Disk Source Drive Loading Data to and Copying from the Hard Disk Source Drive During initialization (see Step 4 on page 7), the DVD Duplicator performs a selftest to detect source drives. The DVD-ROM drive and hard disk drive will be detected as available source drives. The DVD-ROM drive is the default source drive. The internal hard disk drive was formatted and partitioned at the factory. Each partition occupies 9GB of hard disk space.
Loading Data to and Copying from the Hard Disk Source Drive 10 TEAC 1x10 DVD Duplicator User’s Manual
Operation Mode Functions Chapter 3. DVD Duplicator Functions The DVD Duplicator features three (3) modes of operation: ❑ ❑ ❑ Operation mode Setup mode Advanced mode Operation Mode Functions Operation mode includes seven (7) functions. Each function is explained below. Test The Test function simulates writing to the target disc. The discs will remain blank after the test is complete. This function is recommended if you are using unsupported media.
Erase Erase The Erase function erases the data from /RW media. The default setting performs a Quick Erase when you press the RUN button. You can also press and hold the RUN button for three (3) seconds to perform a Full Erase. The Full Erase requires more time than the Quick Erase. Load The factory-installed hard disk drive was partitioned and formatted at the factory. Each partition is approximately 9GB in size.
Setup Mode Functions Setup Mode Functions The Setup mode includes nine (9) functions. To enter the Setup mode, press and hold the SET button until you hear a beep. The LCD will then display SETUP. Press the SET button to scroll through the available functions. To exit the Setup mode, press and hold the SET button until you hear a beep. Each function is explained below. Automatic This function is for factory use only.
CD Writing Speed CD Writing Speed The CD Writing Speed function controls the speed at which the source drive writes to a CD-R disc. The default setting is MX (maximum) write speed. ❑ RUN: Modify parameter. ❑ SET: Save and quit. DVD Reading Speed The DVD Reading Speed function controls the speed at which the source drive reads a DVD disc. The default setting is MX (maximum) read speed. The MID is set according to the highest speed supported by the blank disc. ❑ RUN: Modify parameter.
Advanced Mode Functions Advanced Mode Functions The Advanced Operation mode includes 17 functions. Each function is explained below. Choose Source The Choose Source function enables you to change the device code of the source drive. The default setting is A, which indicates that the system will automatically choose the source drive. ❑ ❑ RUN: Modify parameter. SET: Save and quit. Disc Counter The Disc Counter function keeps track of the number of discs copied during autooperation mode.
CD Writing Way CD Writing Way The CD Writing Way function enables you to select from the three writing methods for CD-R media. The default setting is DAO. ❑ ❑ ❑ ❑ ❑ DAO: Disc at once TAO: Track at once RAW: This is only used when the writer supports RAW writing. RUN: Modify parameter. SET: Save and quit. DVD Writing Way The DVD Writing Way function enables you to select from the two writing methods for CD-R media. The default setting is DAO.
Show Exe. Time Show Exe. Time The Show Exe Time function enables you to find out how long a function’s execution time takes. The default setting is Disable. ❑ ❑ RUN: Enable or disable. SET: Save or quit. Auto Exe. Time The Auto Exe. Time function enables you to set the time allocated for drives to detect blank discs. The default setting is 60 seconds. ❑ ❑ RUN: Modify parameter. SET: Save and quit.
Partition Size Partition Size The Partition Size function enables you to assign different partition sizes to the internal hard disk drive depending on requirements. The default setting is 9GB. Please note that any data that is already present on the partitions will be erased. You will need to reload the data onto the partitions as needed. ❑ ❑ RUN: Modify parameter SET: Save and quit CD Gigarec Rate This function is not supported by the DVD Duplicator.
Appendix A. List of Functions Operation Mode Functions ❑ ❑ ❑ ❑ ❑ ❑ ❑ Test Copy Compare Copy and Compare Verify Erase Load Setup Mode Functions ❑ ❑ ❑ ❑ ❑ ❑ ❑ ❑ ❑ Automatic Partition Name Set as Default Update Firmware CD Reading Speed CD Writing Speed DVD Reading Speed DVD Writing Speed Advanced Setup Advanced Mode Functions ❑ ❑ ❑ ❑ ❑ ❑ ❑ ❑ ❑ ❑ ❑ ❑ ❑ ❑ ❑ ❑ ❑ Choose Source Disc Counter Skip Read Err CD Writing Way DVD Writing Way Check TRK LEN Show Disc Info Show System Info Show Exe. Time Auto Exe.
Appendix B.
Appendix C. About DVD and CD Discs This appendix explains how to handle, load, and eject DVD and CD discs. Handling Discs ❑ ❑ ❑ Handle compact discs only by their edges to avoid getting fingerprints on the surface. Do not touch the disc’s data surface (unlabeled side). Do not place discs in direct sunlight or in locations subject to high humidity, high temperatures, or dusty conditions.
Loading and Ejecting Discs Loading and Ejecting Discs To load a disc into the source or a target drive, first open the disc tray by pressing the Eject button on the front of the drive. Place the disc on the disc tray with its label side facing up. Then press the Eject button again to retract the disc tray back into the drive. To eject a disc from the source or a target drive, press the Eject button on the front of the drive to extend the disc tray.
Loading and Ejecting Discs Appendix D. Specifications The following table lists the product specifications for the TEAC DVD Duplicator. Model DVW-D110H HDD Capacity 160GB Weight 50 lbs. Dimensions (HxWxD) 25" x 7.5" x 16.
Limited Warranty Appendix E. Technical Support and Warranty For technical support, please contact the TEAC America Support Center TEAC America, Inc. (USA) Technical Support Telephone: (323) 727-4860 • Fax: (323) 869-8751 Monday - Friday 8:00 a.m. - 5:00 pm PST http://www.teac.com/DSPD/techsupport-America.htm E-mail: dspdtsg@teac.com Limited Warranty This product is warranted by TEAC America, Inc. against defects in materials and workmanship.
Limited Warranty EXCLUSION OF DAMAGES TEAC’S LIABILITY FOR ANY DEFECTIVE PRODUCT IS LIMITED TO REPAIR OR REPLACEMENT OF THE PRODUCT, AT TEAC’S OPTION. TEAC SHALL NOT BE LIABLE FOR DAMAGES BASED UPON INCONVENIENCE, LOSS OF USE OF THE PRODUCT, LOSS OF TIME, INTERRUPTED OPERATION OR COMMERCIAL LOSS, LOST PROFITS OR ANY OTHER DAMAGES, WHETHER INCIDENTAL, CONSEQUENTIAL, PUNITIVE OR OTHERWISE.
Limited Warranty 26 TEAC 1x10 DVD Duplicator User’s Manual
