Operation Manual

Troubleshooting
FM Tuner
Cannot listen to any station, or the signal is too
weak.
Tune in a station properly.
Rotate the FM antenna until you receive a station
clearly.
MP3/WMA
Cannot play.
Check the MP3/WMA file extension. (see page 9)
MP3/WMA file data might have been broken.
The file data format might not be a MP3/WMA format
The sampling frequency of the file might be more
than 48 kHz.
Cannot display the file information correctly.
If a file information uses Japanese, Chinese or other
double-byte characters, playback is possible but the
name will not be shown correctly.
e
e
e
e
e
e
e
25
ENGLISH
If you have problems with your system, look through this chart
and see if you can solve the problem yourself before calling your
dealer or TEAC service center.
General
No power
e Check the connection to the AC power supply. Check and
make sure the AC source is not a switched outlet and that,
if it is, the switch is turned on. Make sure there is power to
the AC outlet by plugging another item such as a lamp or
fan into the outlet.
No sound from speakers.
e Select the source by pressing the FUNCTION button.
e Check the connection to the speakers.
e Adjust the volume.
e Pull out the headphone’s plug from the PHONES jack.
e If “MUTING” is blinking, press the MUTING button.
The sound is noisy.
e The unit is too close to a TV or similar appliances. Install the
unit apart from them, or turn them off.
Remote control doesn’t work.
e Press the STANDBY/ON switch to turn the unit on.
e When the battery has run out, put in a new one.
e Use remote control unit within the range (5 m) and point at
the front panel.
e Clear obstacles between the remote control unit and the
main unit.
e If a strong light is near the unit, turn it off.
CD Player
Will not play.
e Load a disc with the playback side facing away.
e If the disc is dirty, clean the surface of the disc.
e A blank disc has been loaded. Load a prerecorded disc.
e Depending on the disc, etc. it may not be possible to play
back CD-R/RW discs. Try again with another disc.
e You cannot play back unfinalized CD-R/RW discs. Finalize
such a disc in a CD recorder and try again.
Sound skips.
e Place the unit on a stable place to avoid vibration and shock.
e If the disc is dirty, clean the surface of the disc.
e Don’t use scratched, damaged or warped discs.