Operation Manual

English – 7 | MP-266
Before Using
Charging the Battery
The device has a rechargeable built-in lithium ion battery. It is
charged via USB connection. You are required to charge it when
you use it for the first time.
To charge the battery, connect the larger end of the USB cable to
the USB interface of PC, and connect the other smaller end of the
USB cable to the USB interface of this player. For that remove the
rubber cover to open the USB port. The device is connected to PC
and being charged.
A battery icon like
will be displayed at the upper right corner
of the screen. The following pictures indicate the charging status of
the battery:
1. When the battery is charging, the icon will be charging from an
empty battery to a full one to indicate the process:
Æ .
2. The following icon will replace the charging one when the bat-
tery is full but the power supply is not being cut off.
3. The player will be automatically shut off when the power is used
up. In this case, all settings will be saved.
4. Power saving mode: user can define the time off mode, such as
stop off, sleep off, backlight off to save power.
Notice: The device is not available during charging.
Note:
The MP3 player only accepts the standard USB 2.0 output
voltage and current to charge the built-in Li-Ion battery:
5 Volt voltage and less than 500mA current. If charging volt-
age and current are out of the indicated limits, it will dam-
age the battery and the mp3 player. There will be no war-
ranty in this case. Please make sure the output voltage and
current of the USB port on your PC or USB adapter are suffi-
cient before charging this player. If you found the screen is
blinking during using the USB wall adapter, please use the PC
USB port to charge the player instead of USB wall adapter.