Operation Manual

Notes:

Just after power on the SMR, it may take some waiting period to boot up and

recognize the device by BRC, until it is available in the SMR listing.

The SMR will be ready for playback when the LED indicates static green (Ad-Hoc) or

static blue (LAN and WLAN) light.

If you power on the SMR mains and the BRC at the same time, the BRC is ready

much earlier than the SMR and cannot connect to the SMR though. The BRC will

then show a message window. Just wait until the SMR is ready and then press on

„Yes“ to connect.

To return to the BRC root menu, do a long push of the power button on top of the

BRC and select “Back to BRC”. Please refer the section “BRC Root Menu” in this

manual.

If you need to repeat the connection procedure during the initial config setup, you

can short press the “RESET” button on the SMR backside, to force the SMR to

return into “config mode”, the indication shall flash green/blue again.

Attention: long push on the SMR's RESET button until there is red flashing LED will

completely RESET all settings in the SMR back to default values and then also

returns into config mode with flashing green/blue.