User's Manual

Optional:
Two Additional Speakers
owners manual
8
installation of speakers
installing two SP-628 ceiling speakers
Determine the listening area.
Divide listening area into two quadrants
Locate and identify the center most tile in each quadrant
Lay ceiling tile face down on clean  at surface
Lay tile bridge on ceiling tile and center it
Trace and cut the large hole using a keyhole or drywall
saw
Strip the speaker cable ends, approx. ½"
Route speaker wire from speaker opening to ampli er
Reinstall ceiling tile with tile bridge in place above the
hole
Pull speaker cable back down through speaker hole
With a pointed tool or paper clip, li up and remove
speaker grille
Set speaker on top of ladder and connect speaker cable
connect
Observe speaker polarity, connect Red wire to (+)
terminal and black wire to the (C) terminal
With the mounting clamps folded back, position
speaker into speaker hole
With a #2 Phillips screwdriver, tighten the quick clamps
Reinstall speaker grille and remove any soil or
ngerprints
Repeat same for other speaker
Two wall mount or ceiling speakers can be powered by the receiver/ampli er. It has two ampli ers
(25 watts ea.). One speaker will be connected to each ampli er.
Optional: Two additional speakers can be powered by the ampli er. Connect two speakers in
parallel.  en bring a cable from each pair to the ampli er. Connect one pair to each ampli er.
Forum 232