User Manual

RC28T Manual
:: Step 3 :: Binding
:: Step 2
:: Step 1
2.4GHz 2 Channel Transmitter:
1) Power Switch
2) Steering Trim
3) Steering Wheel
4) Throttle Trigger
5) Battery Compartment
6) Charge Indicator
7) Power Indicator
8) Battery Polarity
9) Vehicle Charge Cord
10) Vehicle Charge Port
11) Vehicle Binding Button
12) Vehicle Power Switch
Battery Charging:
1) WARNING! The vehicle and
transmitter need to be turned off
before you start charging.
2) Make sure you have new batteries
in the transmitter
3) The charging indicator light will
turn green when charging the
vehicle. The indicator will turn off
when the vehicle is fully charged.
4) Unplug the charge cord from the
vehicle.
CAUTION! Always turn vehicle and
transmitter OFF when not in use.
Driving:
1) Turn the transmitter ON FIRST,
vehicle ON SECOND.
2) Adjust steering trim so the front
wheels point straight.
3) Turn the vehicle OFF FIRST,
transmitter OFF SECOND.
CAUTION! Always turn vehicle and
transmitter OFF when not in use.
Pull for
throttle
Neutral
Turn wheel left
to go left, and
right to go right
Push for
brake/reverse
Steering
Trim
8
8
WARNING!
Make sure the batteries are installed
in the right direction, as marked on
the transmitters battery door.
9
1
6
7
3
2
4
5
11
10
12
9
1) Turn on the vehicle and press the BIND button.
The LED on the vehicle will begin blinking rapidly.
2) Turn on the transmitter.
3) When the LED on the vehicle becomes solid,
the binding process is complete.
Binding
Button
Binding/
Power LED