User manual

17
:: Anti-Roll Bars Build - Bag 0 - Step 3
:: Anti-Roll Bars Build - Bag 0 - Step 2
:: Anti-Roll Bars Build - Bag 0 - Step 1
Center the Anti-Roll
Bar Collet on the
Anti-Roll Bar, then
tighten the (#25225)
3x3mm set screw.
!
#1596
thread lock
25225
3x3mm
Set Screw
81150
Anti-Roll
Bar
Collet
81130
(Front) Anti-Roll
Bar, Green (2.4mm)
81140
(Rear) Anti-Roll
Bar, Blue (2.7mm)
Build front
and rear
Anti-Roll Bars
89203
3x16mm
BHCS
x2
Rear Hub Turnbuckles
removed for view clarity.
!
Build front
and rear
Anti-Roll Bars
89203
3x16mm
BHCS
x2
Steering Turnbuckles
removed
for view clarity.
When Installing the
set screw into the
rod ends, tighten to
6mm. Tightening
past 6mm can
damage rod end!
!
!
31521
2.5x8mm
BHCS
25225
3x3mm
Set Screw
x2
x2
81257
3x6mm
Set Screw
x2
Tighten #81257 set screws
just enough to still allow the
anti-roll bar to move freely.
!
#1596
thread lock
#1596
thread lock
Left Side Right Side
Anti-Roll Bar Pivots:
Tighten the Anti-Roll Bar
Rod Ends completely, then
offset the Anti-Roll bar rod
ends as seen above
(approximately 45 degrees).
!
81150
Anti-Roll
Bar Pivot
81150
Anti-Roll
Bar Rod
End
81150
Rod End
Ball
81258
3x12mm
Set Screw
x2
6mm
6mm