User Manual

17
:: Shocks Build - Step 4
:: Shocks Build - Step 5
:: Shocks Build - Step 3
Front/Rear
Shock: 30wt
Step 9-10
Stroke:
26.0mm
Free Length:
86.25mm
Free
Length
Stroke
Stroke
Step 1-3 Step 3-4 Step 5-6 Step 7
Shock Bleeding Steps:
1. Pull shock shaft down.
2. Fill shock body 3/4 full with silicone
fluid.
3. Slowly move the shock shaft up and
down to remove air from under piston.
4. Wait for bubbles to come to surface.
5. Fill shock body to top with silicone fluid.
6. Place a drop of oil in the cap and on
cap threads.
7. Install cap and tighten completely.
8. Slowly compress shaft all the way to
the top. If there is pressure at the top
of the stroke, there is too much oil or
air. You must bleed it out.
9. Slowly pull shaft out.
10. Unscrew the cap 3/4 turn and tilt the
shock at a slight angle.
11. Slowly compress the shaft to push
out excess oil and air. You should see
bubbles coming out from under the
cap.
12. With the shaft compressed, tighten
the cap and re-check for pressure at
the top of the stroke. If there is still
pressure, repeat steps 9 thru11.
Shock fluid
#5422
Shock fluid
#5422
91454
Shock Cap
(Molded)
Front
Shocks
2mm x1
3mm x1
2mm x2
4mm x1
Rear
Shocks
Pre-Load
Spacers
1mm
2mm
3mm
5mm
91636
12mm Shock
Spring (54mm),
White (4.10lb)
Build x2 front and x2 rear shocks
71054
Pre Load
Spacers
91454
Spring
Cup
71054
Spring
Collar
Build x2 (right and left side) Build x2 (right and left side)
Use outside
hole in
front arm!
!
Use outside
hole in
rear arm!
!
25612
M3 Locknut,
with flange
(black)
25612
M3 Locknut,
with flange
(black)
89202
M3 x 12mm
BHCS
91444
Shock
Bushing
91444
Shock
Bushing
25189
M3 x 22mm
BHCS