ASC90020 B6.1 Buggy Manual

14
:: Bag 8 - Step 1
:: Bag 7 - Step 3
:: Bag 7 - Step 2
91722
Ball Cup
91722
Ball Cup
91723
Turnbuckle
3x48mm
28.50mm
Steering Turnbuckle
Build x2 (right and left side)
Racers Tip:
Use black grease
(#6588) on the
threads of the
turnbuckles for
easier ball cup
installation!
Orient the notch
to the left throughout the
car. It indicates which end
has the left hand threads!
!
91562
6 x 13 x 5
Bearing
91563
10 x 15 x 4
Bearing
Build x2 (right and left side)
Do not overtighten the
1.6 x 5mm SHCS into the
Clamping wheel hex.
!
91436
CVA Wheel
Hex Pin
91611
M1.6 x 5mm
SHCS
71034
Clamping
Wheel Hex,
6mm Offset
(rear)
Build x2 (right and left side)Build x2 (right and left side)
91779
Rear Hub
Spacer
91670
Hinge Pin
(rear, outer)
31510
M2 x 4mm
BHCS
x2
91762
HD CVA
Axle, V2
91438
CVA Pin
#6588
black grease
91438
CVA
Coupler
91434
CVA Bone,
67mm
91820
Steering Link
Ball Cup
x2
91821
Anti-Roll
Bar Pivot
x2
4671
M3 x 10mm
Set Screw
25225
3 x 3mm
Set Screw
CVA Axle Holes
There are two hole locations on the #91762 CVA axle.
One is used for the included 67mm CVA bones, and
one for the optional 65mm CVA bones.
Use the inner hole for the included 67mm CVA bones.
67mm hole
location
65mm hole
location
bar flush
with pivot
2mm
#91670 - Hinge Pin will be
tight in the rear hub, but
should rotate freely
in the rear arms.
!