TBS Fusion Video Receiver Manual

INSTALLATION DEETS
The Fusion is an advanced module and uses more power than the
other modules on the market due to WiFi module used for future
Crossfire connectivity. Therefore it is necessary to provide external
power to the Fusion depending on your goggles and on whether
you plan to use WiFi.
DO I NEED EXTERNAL POWER?
DO YOU HAVE HDO’s
OR MODIFIED OLDER
GOGGLES?
NO, I HAVE OLDER
(un-modified) GOGGLES
YES
ARE YOU
PLANNING ON
USING WiFi?
NO YES
Use the external power
board -
INSTALLATION VIDEO
NO EXTERNAL
POWER OR MOD
IS NEEDED
EXTERNAL POWER*
NEEDED
Run a wire from the
power pad of the FUSION
to the barrel connector of
your goggles (2S max)**
6
* Unlike with some inferior modules, you can still turn on/off Fusion using the switch on the bottom
of your goggles when you use external power
** Fusion supports 2S maximum voltage, so don’t do this if you power your goggles with 3S
.