TBS Tracer Manual
Binding issue - OpenTx 2.3.10
When you update your radio to OpenTx 2.3.10 you might find all your receivers are now unbound. If this is
the case, check the model match number. Due to the way OpenTx handels this feature, it might have set
up a model number. In this case just change it back to 00 and your receiver should be bound again.
Transmitter
First you need to set your transmitter in bind mode. For this you got a variety of options, depending on the
radio and transmitter type you use:
Lua script (OpenTX radio only):
1. Turn on your radio
2. Navigate to the Tracer lua script and
execute it
3. Open the
Tracer Transmitter
4. Scroll down to
Bind
and hit enter
TBS Tango 1:
1. Turn on your radio
2. Hold the rocker switch to enter the main
menu
3. Scroll down to
Devices
4. Under
Tracer Transmitter
5. Click on
Bind
Agent X:
1. Connect your transmitter to the Agent X by
USB
2. Open the Tracer Transmitter (
Manage
)
3. Navigate to the
Configure
tab
4. Under
Device
, click on
Bind
Button:
1. Power up the transmitter
2. Push the button of the Micro TX once
Receiver
Vanilla receivers that have never been bound before will automatically accept a bind and do not need to
be placed into bind mode. Receivers that have been bound to the same transmitter also do not need to be
bound again. Placing the Transmitter into bind mode is sufficient. If a bind doesn’t work for some reason,
you can force the receiver into bind mode. This procedure is the same for all receiver types available:
1. Power up the receiver
2. After 1 second, but within 1 minute, push the bind button on the receiver
Note: Do not press the bind button while powering up the receiver. It will not activate bind mode!
16