TBS Tracer Manual
Model-match in OpenTX
Model match enables you to make sure that a specific receiver and drone with it only binds if the correct
radio model is selected. In case you switched from a drone to a wing and forgot to change the model, the
Rx will simply not bind (unless you start the bind procedure).
You need to make sure that you don’t use an id twice in different models. In this case, the Rx will bind to
both of them!
Note:
Model Match with the TBS Tracer is available on OpenTx since V2.3.10
In OpenTX your model number in the memory will be set as default Model ID when you create a new
model. If your receivers are no longer bound after upgrading the OTx version, just set the Receiver
number back to 00.
Model Id (Receiver No.) in OpenTX
36