User manual

15
30
29
Bag-F
300#
Shock Absorber
Dämpfer
Shock Absorber
Dämpfer
Bag-F
Dämpfer Kugelkopf
Shock Ball
TR1039
Dämpferfeder-27N
Spring-27N
TR1029
Federteller unten
Blow Spring Mount End
T01089
……………8
Dämpfer Kugelkopf
TR1039 Shock Ball
x4
x4
Assemble as many times as specified
So oft montieren wie angegeben
x4
mm65
0%
100%
25%
50%
Nach dem Zusammenbau müssen Sie den Dämpfer Rebound einstellen.
After the shock is assembled you have to set the shock rebound.
1 3
2
1
Lösen Sie die Dämpferkappe mit 2-3 Umdrehungen.
Release the shock cap by 2-3 turns.
2
Push the shock shaft fully up .For the first time the extra oil will release through the hole in
the alu cap-nut. Drücken Sie die Dämpferstange komplett nach oben. Beim ersten mal
wird etwas Öl aus dem kleinen Loch entweichen.
3
Tighten the shock cup .When tightening the shock cup,extra oil will again release through
the hole in the alu cap-nut.When tightening,the shock shaft will push out from the shock
body. Dämpferkappe wieder festziehen. Wenn Sie die Dämpferkappe festziehen wird
ein bisschen Öl wieder aus dem kleinen Loch austreten. Beim festziehen wird die
Gewindestange wieder nach unten gedrückt.