User Manual
Toe: ________________________________________________
Ride Height: ______________ Camber: _________________
Caster: 0º 5º
Kick Angle: 20º 25º 30º
VLA Setting: Short Arm Long Arm
Front Pivot: Alum Plastic HRC Alum HRC
Kick Shim: Brass Plastic
Oil: ________________________________________________
Piston: _____________________________________________
Spring: Standard Low Freq. Color: ________________
Sway Bar: 0.8mm 1.0mm 1.2mm ______________
Shock Limiters: _____________ Stroke: _________________
Shock Locations: ____________________________________
Spindle Ball Stud: Standard Low Mount
Bump Steer Spacers: _________________________________
Ackerman Ball Stud: Standard Low Mount
Ackerman Spacers: __________________________________
Ackerman Arm: #1 #2 #3 _____________________
Axle Spacing: 0 +0.5mm +1mm
Trail: 2mm 3mm 4mm
Camber Link: _______________________________________
Configuration: Laydown Standup
LD Diff. Height: Standard +3.5mm
Transmission Type: 3-Gear 4-Gear
Toe Inserts: 0.5 1 1.5 2 2.5 3 3.5 4
Anti-Squat Inserts: 0 0.5 1 1.5 2 2.5 3
Inner Roll Center: LRC HRC
Ride Height: ______________ Camber: _________________
Rear Hub Spacing: __________________________________
Rear Axle Height: Standard +3mm
Hex Width: _________________________________________
Sway Bar: 1.0mm 1.2mm 1.4mm _______________
Oil: ________________________________________________
Piston: _____________________________________________
Spring: Standard Low Freq. Color: ________________
Shock Limiters: _____________ Stroke: _________________
Shock Locations: ____________________________________
Shock Mounting: Front Rear
Inner Link Spacer: -1mm 0mm +1mm
Camber Link: _______________________________________
Wing/Wickerbill: ____________________________________
Wing Angle: 0° 2° 4°
Battery Position: ____________________________________
Dif
f Type: Ball Gear Setting: _______________________
Driveshaft Length: CVA Universal Length: __________
Tire: __________________________
Compound: _________________________
Insert: __________________________
Additive: __________________________
Notes: _______________________________
_____________________________________
_____________________________________
Radio: _________________
Servo: _________________
ESC: ___________________
Initial Brake: ___________
Drag Brake: ____________
Throttle Profile: ________
Timing Advance: ______________
Throttle/Brake Expo: __________
Servo Expo: ___________________
Throttle/Brake EPA: ___________
Motor: _______________________
Pinion: _________Spur: _________
Battery: ______________________
Notes: ______________________________________________
____________________________________________________
____________________________________________________
____________________________________________________
Grass
Astro Turf
Low Bite
Med Bite
High Bite
Other
Wet
Dusty
Blue Groove
Dry
Hard Packed
Loose/Loamy
Smooth
Rough
Tight
Open
Indoor
Outdoor
Track
Conditions
Front Suspension
Rear Suspension
Name:
City: State:
Date:
Track:
Event:
Front Rear
Tires
Chassis
Electronics
1
2
3
_______
SPACER
_______
SPACER
_______
SPACER
_______
SPACER
INSIDE
MIDDLE
LONG
A
1
2
B
SHORT
OUTSIDE
_______
SPACER C B A
1
E D
2
3
OUTSIDE
MIDDLE
INSIDE
13
2 Laydown
2 Standup
D
_______
SPACER
Front Pivot
Brass Pivot, 50g
Brass Kick Shim, 7g
Electronics Plate
Brass, 25g
Brass, 50g
_________
Anti-Squat Block
Brass, 27g
Aluminum
Rear Ballasts
Brass, 25g
Brass, 50g
Battery Plate
_________
Servo Plate
Brass, 14g
_________
76
76
Dakotah Phend
September 2017
TLR Cup West
Aurora
CO
MHOR RC Raceway
✔
✔
✔
✔
✔
✔
✔
+/- 0
23.5mm
-1 deg
✔
✔
✔
✔
✔
32.5 wt
2 x 1.6mm (TLR233009)
AE Grey
None
3mm
23mm
2 - Middle
✔
0.5mm
✔
0mm
✔
✔
✔
1 - A
1mm
2mm
1mm
3mm
✔
✔
✔
✔
✔
✔
23mm (toe plate)
-1 deg
2mm front, 2mm rear
✔
Standard
✔
None
27.5 wt
2 x 1.7mm (TLR233010)
✔
White
0mm
31mm
2 - Middle
✔
✔
2 - B
Narrow Front Wing(on tower), TLR 6.5", 2 lines
✔
Full back (laydown)
✔
Normal
✔
68mm
2mm
0mm
DX6R Pro
SPMSS6240RX
Orion HMX
VST2 LW Pro 7.5T
22
76T
Orion 3800mAh Thin LiPo
✔
✔
AKA Handlebar
AKA Impact
Soft
Soft
AKA Red
AKA Red
Soft rear arms, batter taped in.