User Manual

Toe: ________________________________________________
Ride Height: ______________ Camber: _________________
Caster: 0º 5º
Kick Angle: 20º 25º 30º
VLA Setting: Short Arm Long Arm
Front Pivot: Alum Plastic HRC Alum HRC
Kick Shim: Brass Plastic
Oil: ________________________________________________
Piston: _____________________________________________
Spring: Standard Low Freq. Color: ________________
Sway Bar: 0.8mm 1.0mm 1.2mm ______________
Shock Limiters: _____________ Stroke: _________________
Shock Locations: ____________________________________
Spindle Ball Stud: Standard Low Mount
Bump Steer Spacers: _________________________________
Ackerman Ball Stud: Standard Low Mount
Ackerman Spacers: __________________________________
Ackerman Arm: #1 #2 #3 _____________________
Axle Spacing: 0 +0.5mm +1mm
Trail: 2mm 3mm 4mm
Camber Link: _______________________________________
Configuration: Laydown Standup
LD Diff. Height: Standard +3.5mm
Transmission Type: 3-Gear 4-Gear
Toe Inserts: 0.5 1 
1.5 2 2.5 3 3.5 4
Anti-Squat Inserts: 0 0.5 1 1.5 2 2.5 3
Inner Roll Center: LRC HRC
Ride Height: ______________ Camber: _________________
Rear Hub Spacing: __________________________________
Rear Axle Height: Standard +3mm
Hex Width: _________________________________________
Sway Bar: 1.0mm 1.2mm 1.4mm _______________
Oil: ________________________________________________
Piston: _____________________________________________
Spring: Standard Low Freq. Color: ________________
Shock Limiters: _____________ Stroke: _________________
Shock Locations: ____________________________________
Shock Mounting: Front Rear
Inner Link Spacer: -1mm 0mm +1mm
Camber Link: _______________________________________
Wing/Wickerbill: ____________________________________
Wing Angle: 0° 2° 4°
Battery Position: ____________________________________
Diff Type: Ball Gear Setting: _______________________
Driveshaft Length: CVA Universal Length: __________
Tire: __________________________
Compound: _________________________
Insert: __________________________
Additive: __________________________
Notes: _______________________________
_____________________________________
_____________________________________
Radio: _________________
Servo: _________________
ESC: ___________________
Initial Brake: ___________
Drag Brake: ____________
Throttle Profile: ________
Timing Advance: ______________
Throttle/Brake Expo: __________
Servo Expo: ___________________
Throttle/Brake EPA: ___________
Motor: _______________________
Pinion: _________Spur: _________
Battery: ______________________
Notes: ______________________________________________
____________________________________________________
____________________________________________________
____________________________________________________
Stiffezel Parts:
Front Arm Rear Arm
Chassis Brace
Front Camber Block
__________________
Grass
Astro Turf
Low Bite
Med Bite
High Bite
Other
Wet
Dusty
Blue Groove
Dry
Hard Packed
Loose/Loamy
Smooth
Rough
Tight
Open
Indoor
Outdoor
Track
Conditions
Front Suspension
Rear Suspension
Name:
City: State:
Date:
Track:
Event:
Front Rear
Tires
Chassis
Electronics
1
2
3
_______
SPACER
_______
SPACER
_______
SPACER
_______
SPACER
INSIDE
MIDDLE
LONG
A
1
2
B
SHORT
OUTSIDE
_______
SPACER C B A
1
E D
2
3
OUTSIDE
MIDDLE
INSIDE
13
2 Laydown
2 Standup
D
_______
SPACER
Front Pivot
Brass Pivot, 50g
Brass Kick Shim, 7g
Electronics Plate
Brass, 25g
Brass, 50g
_________
Anti-Squat Block
Brass, 27g
Aluminum
Rear Ballasts
Brass, 25g
Brass, 50g
Battery Plate
_________
Servo Plate
Brass, 14g
_________
47
47
























Kit Setup - Spec Racer
+/- 0 deg
23mm
32.5 wt
2 x 1.6mm (TLR233009)
1mm 22mm
1 - Middle
1mm
1mm
2 - B
Silver
-1 deg
23mm
Middle (2mm front, 2mm rear)
Standard
32.5 wt
2 x 1.7mm (TLR233010)
1mm
2 - Middle
2 (Standard) - E
6.5” - 1 line wicker
Shorty with battery strap
Normal, 3/4–1 Rotation
67mm
29mm
69T
White
-1.5 deg
1mm
2mm
2mm
3mm
2mm
0mm