User Manual

10
5.5mm
Rear “DIG”
2mm
Full Time
4wd
6mm
Front “Dig”
To take advantage of the Comp Crawlers
“front & rear” dig setup, a Radio System
such as the Spektrum DX3R with a 3-posi-
tion Aux channel is required. A 2-position
Aux channel can be used as well, however
only “front” dig can be used.
If you will not be using the optional Dig
system, remove the small tie rod attached
to the shift horn.
A Losi MSX12 (LOSB0822) Mini Digital
Servo is required to use the dig options.
Caution: When setting up the Comp
Crawler with dig, it is important to set
your AUX channels Travel/EPA (End
Point Adjustment) to “Zero” in any
direction. If this is not done, servo failure
can occur.
Once the proper dig arm is attached to your
servo (Losi, JR, Airtronics & KO Propo
23T, Hitec 24T, Futaba 25T) and is cen-
tered, you can now adjust the Travel/EPA
settings for each direction. While adjust-
ing the travel, note that once the Dig shaft
stops moving, you can stop adjustment.
If any more travel is set, the Mini Servo
could encounter damage.
•
•
•
•
•
Step D
Outer Transmission Assembly
STEP D-03
q
“DIG” Servo Installation
STEP D-04
q
A3166
Idler Gear
A3165
Outer Trans Case
A3171
Slipper Pad
A3170
Slipper Plate
A3170
Slipper Spacer
A3170
Slipper Gear
4-40” x 5/8”
x3
A6221
5x11x4mm
x2
A6947
A3167
Idler Shaft
L 4-40 x 1/4”
x1
A6308
4-40” x 3/8”
x6
A6229
1/8” x .020”
x6
A6350
3/16”
x2
A6001
L 4-40 x 1/4”
x2
A6308
L 4-40 x 3/16”
x1
A6306
4-40” x 5/8”
x1
A4038
A4038
Rod End
A4038
Shift Horn
A4038
Dig Arm