User Manual

ManualsBrandsTeam Losi Racing ManualsHobbyXXX-NT Adam Drake 2 Kit

SERVO TYPE

MOUNTING POST

PIN LOCATION

REQUIRED

SERVO ARM

STEERING LINK

LENGTH

AIRTRONICS

All

Futaba

S131, S131SH, S148, S3001, S5101,

S9101,S9201, S9301, S9401, S9403

Futaba

S3401, S9402, S9404, S9450

Futaba

S9303

HiTech

HS-605, HS-615, HS-925, HS-945

HiTech

All other's

NES-507, NES-513, NES-517, NES-901,

NES-4000, NES-4131, NES-4721,

NES-4735, NES-9021,DS-8231

PS-702, PS-703, PS-1001, PS-1003

PS-901BH, PS-902

Multi

lex

All

** Use 1 Ball Stud washer on the ball stud when attaching it to the servo arm.

2 25 C-6A

4** 25 C-6A

3** 24 C-6B

1 or 3 23 C-6A

3 25 C-6A

1 24 C-6B

1 23 C-6A

2 23 C-6A

C-6A23

G C (ContinG C (Contin

G C (Contin

ued)ued)

ued)

Table C-3C

Figure C-3A

Figure C-3B

Step C-4Step C-4

Step C-4

 1. Use the tables in Figure C-3A and C-3B (Shown above) to

determine how the servo mounting posts (24) should be attached to

the servo (not included).

Trim any flashing from the pins on the mounting posts

so that they will seat all the way into the holes in the chassis brace

and chassis.

 2. Place a #4 washer (23) over each of the four 4-40 x 3/8" cap-

head screws (17) and attach the servo posts to the servo by thread-

ing a screw through the upper and lower holes in each post. Do not

tighten the screws yet! Just snug them up so that the posts are held

in place, but can still be moved from side to side with a little resis-

tance. The screws will be tightened after the servo is installed so that

the posts have the correct spacing.

Place a Body Clip between the servo case and servo

Mounting Post before tightening the mounting screws. Center the

posts vertically and tighten the four mounting screws. For most servo

manufactures this will space the servo mounting posts perfectly.

Figure C-4

Servo Mounting Post Install:

Step C-3Step C-3

Step C-3

Servo Mounting Chart: