User Manual

Figure C-10

G C (ContinG C (Contin

G C (Contin

ued)ued)

ued)

Step C-8Step C-8

Step C-8

Step C-9Step C-9

Step C-9

 1. Press a rubber Tank-Mounting Grommet (28) into each of the

three large holes in the top of the Chassis Brace (29) as shown. The

chassis brace should seat into the grove on the outside of the Grom-

met.

 1. Line up the three posts on the Fuel Tank (30) with the three

holes with Grommets in the Chassis Brace (29). Install the Fuel Tank

on the Chassis Brace from the bottom by pressing the three Posts on

the Tank through the three Rubber Grommets (28).

IMPORTANT NOTE: Push around the outer edges of the Fuel

Tank while pressing the Tank into the Grommets. This will prevent

cracking the seal around the bottom of the tank.

The Screws should not be tightened so that Grommet

smashes. By tightening the Screws until the washers just touch the

Grommets, the tank will be "shock mounted". This helps the fuel

from foaming while the truck running.

 2. Place a #4 Washer (23) over each of the three 4-40 x 3/8" Cap-

Head Screws (17). Thread a Screw through each of the Grommets and

into the posts in the Fuel Tank. Hold the Tank all the way up against

the Chassis Brace. Tighten each of the three Screws (14) until the

Washer just touches the Grommet.

Figure C-8

Figure C-9

Tank Grommet Install:

Tank Install:

Step C-10Step C-10

Step C-10

Fuel Line Clip Install:

 1.Attach the Fuel Line Clip (84) to the Chassis (19) by placing a

4-40 x 3/8" Flat-Head Screw (20) into the through hole in the Chassis

and thread the screw into the Fuel Line Clip, hold the Clip so it re-

mains parallel with the sides of the chassis and tighten.

*NOTE: The clip should run parallel with the length of the Chassis.