User Manual

G C (ContinG C (Contin

G C (Contin

ued)ued)

ued)

Step C-11Step C-11

Step C-11

There is a short Thread-Cutting Screw included in the wrench bag. This Screw can be used to tap threads in the holes in the

Chassis Brace. Pre-tapping these holes makes it easier to install the Screws during assembly.

 1. Place the Chassis Brace (29) on top of the Chassis (19). Pay particular attention to the Servo Posts (24). The pins in the top of the Servo

Posts should fit into the two holes in the Chassis Brace. Once the Chassis Brace is lined up and in place, secure it to the Chassis with six 4-40

x 3/8" Flat-Head Screws (20) as shown.

 2. Place a Ball Stud Washer (9) over two 4-40-1/2" Cap-Head Screws (31) and thread the screws into the front of the Chassis Brace, through

the front Bulkhead (32) and into the front Kickplate (14) and tighten.

*NOTE: Make sure that the pins on the top and bottom of the Servo Posts stay located in the holes in the Servo Post Bushings and

Chassis Brace, and that the Servo are as close to centered between the two Servo Posts as possible.

Figure C-11

Chassis Brace Install: