User Manual

215
107
108
110
109
119
71
109
113
106
9
10
119
BB
BB
B
AA
AA
A
G DG D
G DG D
G D
13
Step D-1Step D-1
Step D-1Step D-1
Step D-1
Step D-2Step D-2
Step D-2Step D-2
Step D-2
Figure D-2
Figure D-1
Step D-3Step D-3
Step D-3Step D-3
Step D-3
The XXX-NT AD2 has two options available for se-
curing the rear Wheels and Tires, both a Quick Release Lever system
and Lock Nut system are included in the XXX-NT AD2 Kit.
 1. To utilize the Quick Release Lever system the Retaining Lever
(211) and Spring (210) must be used. Place the Spring in the orientaion
shown in Figure D-3, with the Lever in between the legs of the Spring.
The Spring is set into the grove on the Lever.
 1. A standard wheel nut can also be used by removing the Re-
taining Lever and Spring and using the the Threaded Axle Adapter
(212).
IMPORTANT NOTE: In order for the spring to be properly
tensioned it must be secured into the groove on the Quick Release
Lever.
Figure D-3B
 1. Apply a small amount of Thread Lock (119) to a 4-40 x 3/32 Set
Screw (108) and thread it into the Cross Bone Coupler (215).
 3. Place the greased Cross Bone Coupler into the large hole of
the Cross Bone. Align the hole in the Coupler with the slot in Cross
Bone and insert the Cross Bone into the large end of the Rear Axle.
 4. Secure the three parts by sliding a 1/16" x 3/8" Drive Pin (110)
through the holes in the Rear Axle, Cross Bone, and Coupler. Center
the Drive so the ends do not pertrude past the edges of the Rear Axle.
 2. Apply a thin coating of Thrust Bearing Assembly Grease (71)
to the Cross Bone Coupler, Cross Bone(107), and inside of the Rear
Axle (109).
 5. Tighten the Set Screw in the Coupler to lock the Drive Pin in
place.
IMPORTANT NOTE: Ensure that the Drive Pin is centered in
the Rear Axle.
 6. Make two of these assembly's.
 1. Press a 10mm X 15mm Bearing (106) in the the backside of the
Rear Hub (113). Slide the Rear Axle assembly through the bearing as
shown.
 2. Slide the Second 10mm X 15mm Bearing over the Rear Axle
and press it into the frontside of the Rear Hub.
 3. Place a Ball Stud Washer (9) over a 1/4" Ball Stud (10) and
thread it into the middle camber link hole on the top of the Rear Hub.
 4. Make two of these assembly's.
*NOTE: Apply a drop of Thread Lock to ensure the Ball Stud does
not come loose.
9
10
211
210
212
Cross Bone Coupler:
Cross Bone Assembly:
Quick Change Assembly:
106
Figure D-3A
108
110
215