User Manual

1. Clean any dirt or oil off the screw by wipping the threads of the
screw (111) on a rag. This will ensure that the Thread Lock (119) will
stick to the threads of the screw.
2. Remove the #4 Washer (23) marked "Do Not Use" during this
step.
3. Apply Thread Lock to threads at the very end of the screw
farthest away from the head, before installation.
STOP
! The washers marked "Do Not Use" in the diagram, have been removed and should not be used under any
ci
rcumstances. The parts are included in the assembly bags, and can be used in other applications, However, Do Not
use the washers in this application.
READ THIS FIRST!
Step D-5
Rear Hub Install
115
113
Do Not
Use
111
118
119
Do Not
Use
800-0226