User Manual

ManualsBrandsTeam Losi Racing ManualsHobbyXXX-NT Adam Drake 2 Kit

115

113

111

118

119

109

112

113

210

211

117

G D (ContinG D (Contin

G D (Contin

ued)ued)

ued)

Figure D-5

Step D-4Step D-4

Step D-4

Step D-5Step D-5

Step D-5

Figure D-4

 1. Push an Arm Bushing (115) from between the ears of the Rear

Arm into the outside holes of the Rear Arm (118). Ensure that the lip

on the bushing is located between the ears of the Rear Arm.

 2. Place the Rear Hub (113) between the ears of the Rear arm, the

flange of the Arm Bushing should be positioned between the Rear

Hub and Rear Arm.

 3. Apply Thread Lock (119) to two 4-40 x 3/8" Button-Head

Screws (111) and place a #4 Washer (23) over each Screw. Align the

holes the Rear Hub and Rear Arm and thread the screw into the Rear

Hub, and tighten.

 4. Repeat Steps 1-3 for the right rear arm assembly.

*NOTE: The Rear Hub should rotate freely in the Arm when the

Screws and Arm Bushings have been installed and tightened.

 1. Slide the Wheel Hex (112) over the Rear Axle (109).

 2. Place the Retainer Spring (210) in the orientaion shown in

Figure D-3, on previous page, with the Retaining Lever (211) between

the legs of the Spring. Make sure the Spring is set into the groove on

the Retaining Lever.

 3. Hold the Retainer Spring and Lever assembly together be-

tween your fingers and slide it inside of the Rear Axle (109) until the

holes on the Axle and Retainer Lever are lined up.

 4. Slide the Wheel Hex up to the outside Bearing and rotate the

the Hex until the through holes in the Wheel Hex, Axle, and Retainer

Lever are all lined up.

*NOTE: The Drive Pin should slide through one side of the Wheel

Hex and press into the opposite side to keep the Pin from falling out.

When installing the Drive Pin, First insert the pin in larger hole

then push it through the Axle and Lever.

 5. Push the 1/16"x1/2" Drive Pin (117) into the Wheel Hex, Rear

Axle, and Retainer Lever, unitl the Pin is flush with the side of the

Wheel Hex.

 6. Repeat steps 1-5 for the second assembly.

IMPORTANT NOTE: Make sure that the Drive Pin goes through

the Wheel Hex, Rear Axle, and Retainer Lever. The Drive Pin holds all

three parts togther.

Wheel Hex and Lever Install:

Rear Hub Install:

111

115

117