User Manual

122

104

118

G D (ContinG D (Contin

G D (Contin

ued)ued)

ued)

Figure D-7

Step D-7Step D-7

Step D-7

Figure D-6

 1. Thread a 4-40 x 1/8" Set-Screw(134) into each hole on the

bottom of the Rear Pivot Block (104). Just thread it in far enough to

start the Set-Screw, it will be tightened in the next step.

Step D-6Step D-6

Step D-6

IMPORTANT NOTE: The Rear Pivot should be installed so that

the Set Screws are Tightened from the Bottom of the Chassis, also the

word "TOP" molded into the Rear Pivot Should be installed towards

the front of the truck.

 1. Position the rear Pivot Block (104) onto the rear of the Chassis

and line up the mounting holes in the Chassis and rear Pivot Block.

The word "TOP" is molded on to the upper front portion of the rear

Pivot Block.

 2. Thread a 4-40 x 3/8" Flat-Head Screw through the bottom of

the Chassis and into each of the 4 mounting holes in the rear Pivot

Block.

 3. Position the rear Arm (118) inside the ears on the rear Pivot

Block and line up the holes in the rear Arm and Pivot. Slide a rear inner

Hinge Pin (122) through the Rear Arm and Pivot until the end Hinge

Pin is flush with the front face of the Pivot.

 4. Snug the two 4-40 x 1/8" Set-Screws (134), which were installed

in Step D-6, to keep the Hinge Pin from working lose, these Set-

Screws do not need to be very tight.

 5. Repeat for right Rear Arm assembly.

122

Rear Pivot Set Screw Install:

Rear Suspension Install:

134

104

134