User Manual

Apply Clear

Grease Here.

G EG E

G E

Step E-2Step E-2

Step E-2

Step E-3Step E-3

Step E-3

 1. Locate the 5/64" Allen Wrench (59) supplied with the kit. Place

the Diff Nut(57), tab side first, over the Allen Wrench.

 2. Stack 12 Belleville Washers (58) over the Wrench, next to the

Diff Nut. The Washers should all point the same direction with the

concave side facing away from the Diff Nut as shown in Figure E-1B.

 1. Insert all of the parts that are stacked on the wrench into the

Male Outdrive (60). Line up the tabs on the Diff Nut (57) with the slots

in the Outdrive. Press the parts all the way into the Outdrive.

 1. Apply a small amount of Diff Grease (clear) (62) all the way

around the face of the outside ridge of the Outdrive(60). Attach a Diff

Ring (61) to the Outdrive by centering the hole in the Diff Ring over

the raised center of the Outdrive.

*NOTE: Only a small amount of Grease is needed, but be sure to

cover the entire face of the ridge on the Outdrive.

IMPORTANT NOTE: Do not glue the Diff Rings to the Outdrives.

Doing so may not allow the Diff Rings to mount flat.

Figure E-1B

Figure E-1A

Figure E-3

Figure E-2

Belleville washers should be stacked like this

Step E-1Step E-1

Step E-1

Diff Nut Assembly:

Male OutDrive Assembly:

Diff Ring Assembly: