User Manual

G E (ContinG E (Contin

G E (Contin

ued)ued)

ued)

Step E-9Step E-9

Step E-9

Figure E-9

 1. Locate the Brake Shaft (77) and press the .078" x 3/8" Spirol Pin

(78) into the small hole away from the grooved end of the Brake Shaft

so that it extends evenly from both sides of the Shaft.

 2. Press the Compound Gear Bushing (181) all the way into the

end of the Compund Gear (79). Slide the Compound Gear, with the

Bushing in place, over the Brake Shaft. Align the groove in the Gear

with the Pin and push the Gear over the Pin.

 3. Secure the Compound Gear and Bushing to the Shaft by snap-

ping a 3/16" C-clip (76) into the groove in middle of the Brake Shaft.

Step E-10Step E-10

Step E-10

Figure E-10

 1. Insert two 3/16" x 3/8" sealed Bearings (80) into the two top

bearing seats of the right Gearbox Half (82).

*NOTE: If any of the supplied Gearbox Bearings only have one

Teflon™ seal(colored, woven looking) in it, position the seal to the

outside of the Gearbox half. This will help shield the Bearing from

dirt and other contaminates.

 2. Insert a 1/2" x 3/4" Bearing (81) into the lower Bearing seat of

the right Gearbox Half.

Compound Gear Assembly:

Right Gear Box Bearing Assembly:

181