User Manual

G E (ContinG E (Contin

G E (Contin

ued)ued)

ued)

Step E-15Step E-15

Step E-15

 1. Slide the Slipper Backing Plate (89) over the Slipper Shaft (73), aligning the flat sections on the Slipper Shaft with the flat sections of the

Slipper Backing Plate.

Place a drop of glue to the Spur Gear before locating the slipper pad to the notches on the spur gear. This will make the assembly

of slipper easier.

 2. Place the Slipper Pad (90) on one side of the Spur Gear (91) and align the notches on the Spur Gear with the notches on the Slipper Pad.

 3. Place the Spur Gear, pad side first, over the Slipper Shaft. The Slipper Pad should rest against the Slipper Back Plate.

*NOTE: Ensure that the notches in the Slipper Pad remain indexed in the Spur Gear.

 4. Install the second Slipper Pad to the exposed side of the Spur Gear. Again, align the notches on the Spur Gear with the notches on the

Slipper Pad.

 5. Place the second Slipper Backing Plate (89) over the Slipper Shaft so that the large, flat surface of the Slipper Backing Plate rests against

the Slipper Pad.

 6. Slide the Slipper Spring Adaptor (92), large side first, onto the Shaft and against the outer Slipper Backing Plate.

 7. Place the gold Slipper Spring (93) over the Shaft, followed by the Spring Retaining Washer (94), small side first, and secure with the 4-40

steel Locknut (95).

IMPORTANT NOTE: Before tightening the Nut, check to see that the Slipper Pads are properly aligned with the Spur Gear on both sides.

If not, align them before proceeding.

 8. Tighten the 4-40 Locknut all the way down, then back it off four full turns (e.g., 360

x 5). This is a good starting point for adjustment.

Final adjustment can be made later.

Figure E-15

Slipper Clutch Assembly: